6 min read OTR Technical Guide

OTR Application Map for ADTs, Loaders, Dozers, Graders and Cranes explains the operating evidence, measurements and asset details needed to evaluate this tyre topic consistently across a fleet or worksite.

Components That Must Agree

Before using OTR Application Map for ADTs, Loaders, Dozers, Graders and Cranes in planning, separate permanent asset data from conditions that changed during the shift.

For OTR Application Map for ADTs, Loaders, Dozers, Graders and Cranes, the vehicle or machine variant, axle or wheel position, tyre identification, rim data and actual duty must describe the same physical configuration. Similar dimensions or a catalogue label should be checked against the exact components in service.

OTR Application Map for ADTs, Loaders, Dozers, Graders and Cranes — Field Data Sheet

Complete the sheet on the actual asset. Photograph markings and keep measured load or clearance data beside the document from which the permitted configuration was taken.

Load and duty

Measured operating load, surface, speed and working cycle.

Asset

Vehicle or machine model, variant, axle layout and operating role.

Wheel

Rim marking, component condition, spacing and installed position.

Configuration Check on the Asset

  1. Record tyre and wheel markings without abbreviating them.
  2. Confirm axle, position, load and clearance conditions.
  3. Compare documents that refer to the same components.

Reading the Configuration Sheet

Use the OTR Application Map for ADTs, Loaders, Dozers, Graders and Cranes result alongside the current machine, vehicle and tyre documentation for the exact configuration in service.

All technical guides